Solution to repair car body,and how to used Auto body dent hammer set
In General,Minor body damage occurs all the time. Door dings, bumper scrapes, scratches — these are all things that you may have a shot at repairing yourself.
Before diving into body repair and learning how to get it done in your driveway, assess your skill level. If you've never attempted any fixes like this before, you aren't going to get absolute perfection the first time. If you want a perfect repair, find a really good body shop (get a referral from somebody who has done business with them) and have your vehicle fixed properly. Sometimes, the cost of professional auto body repairs is worth it. But if you are patient, determined, and want to save money, now's the time to try to fix your dents on your own. Just know that you may have to do it more than once to get a satisfactory result and that you probably won't end up with a result that looks as good as a professional repair.
You will use by car body dent hammer set to repair car body, It is designed to handle most metal fabrication and body repair jobs. Use the hammers and dollies to remove dings and dents, flatten metal panels, create outside curves and shrink metal
Operating requirements of car body dent hammer set
- Master the sheet metal hammer through training
- Wipe off the oil stains on the hammer surface and handle before use to avoid slipping off and hurting people.
- Check whether the handle is loose to avoid accidents caused by the hammer head coming out.
Operating steps of sheet metal hammer
- Easily hold the end of the handle (equivalent to 1/4 of the full length of the handle) with your hand.
When holding the hammer, the index finger and middle finger under the hammer handle should be properly relaxed; the little finger and ring finger should be relatively tight, so that they form a more flexible shaft.
- When hammering the workpiece, keep your eyes on the workpiece and find the point where the hammer hits.
The key to the quality of hammering operation lies in the selection of the drop point. Generally, the principle of "big first, then small, first strong and then weak" should be followed, and the hammer should be struck in sequence from the place where the deformation is larger to ensure that the hammer head falls on the metal surface on a flat surface. At the same time also pay attention to the sheet metal parts
- Gently tap the surface of the body member by shaking with the wrist, and use the spring-back force generated when the part is struck by a golden hammer to make a circular motion.
