Bearing Puller
Automotive Tools
- Wheel Bearing Removal Tool
- Ball Joint Separator
- Brake Caliper Tool
- Oil Filter Wrench
- Coil Spring Compressor
- Injector Puller
- Bush Tool
- Altermator Puller Puller
- Engine Timing Tools
- Clutch Alignment Tool
- Engine Compression Tester
- Engine Repair Tools
- Injector Seat Cutter
- Mechanic Creeper
- Oil Drain Plug Key Tool
- Fluid Oil Extractor
- Brake Bleeder
- Fuel Tank Wrench
- Wiper Arm Puller
- Motorcycle Chain Breaker
Truck Repair Tools
Mechanic Tools
Plastic Auto Tools
instruction for ball joint removal tool (Fork type)
Ball Joint Separator (fork type)
Can be used for tie rod end, pitman arm and ball joint removal.
This type of tool (wedge) will damage the dust seal on the parts that are removed with this tool. If you are reusing any of these parts use the damage free type of tool.
INSTRUCTIONS:
Always wear safety glasses and gloves.
1. Loosen fastener nut, but do not remove completely.
2. Place “wedge” between the two parts being separated.
3. Using hammer strike wedge until it separates.
4. Remove the fastener nut completely and replace the part.
Note: Always replace locking hardware-cotter keys, etc.
Are you looking for a reliable manufacturer of down home textile products?
We can quickly provide customers with market analysis, technical support and customized services.
- Ningbo Dongning Tools Co.,Ltd
- Professional Chinese Tools manufacturer on hand tools& automotive tools
- Address
- No.6 Falan Rd,Hengjie Town,Ningbo City,Zhejiang,China
- Phone
- 86-574-88298696 / 86-574-87070383
- info@nbdntools.com
subscription