Bearing Puller guide: choose right puller for your work

Question

Accepted Answer

DNT pullers are manufactured to a very high specification and subjected to rigorous testing - far exceeding their stated capacities. The legs and beams are drop forged from high quality steel and then heat treated for extra strength and durability. Pullers are normally classified as either hydraulic or mechanical with many different types within these two styles

Choosing the right puller for the job

	Decide what ‘spread’ is required. This is determined by the width of the part to be pulled.	Estimate out what ‘force’ is required. More force may be required for rusted parts or where there is a large area of surface contact. Hydraulic pullers enable maximum force to be applied with minimum effort. Alternatively, choose a puller whose force screw diameter is at least half the size of the shaft of the item to be removed. If in doubt, use the next largest - using an undersized puller will slow down the job and lead to frustration

Always use a 3 leg puller if possible. This gives a better load distribution and is much safer in use.	Decide what ‘reach’ is required. This must be at least equal to or larger than the depth of the part which needs removal.

Types of Puller

	Hydraulic Pullers These have a simple, grease-filled ram instead of a mechanical force screw, producing extra power with ease. The spring loaded plunger provides direct, non twisting application of thrust which is more effective and more secure.		Blind Housing Bearing Removers These operate without the need to dismantle machinery or remove the running shaft.
	Loadstar Hydraulic Pullers Various styles available; Loadstar 8, 12 & 20 Tonne and Loadstar ‘Plus’ 20, 30 & 50 Tonne. For heavy duty pulling and extracting.		Separators For where all round support is required or where there is insufficient space for standard puller legs
	Mechanical Pullers These use a mechanical force screw		Slide Hammers Used when there is no shaft, making a conventional puller unsuitable.
	Thin Jaw Pullers These have special legs for use where clearance is limited behind the gear or bearing race. Available in both hydraulic and mechanical.		Split Collet Extractors For blind housing internal use. The split collet is pushed into the centre of the bearing and then expanded via the hex nut on the end of the collet.

Quick Reference Guide

Chinese Tools Manufacturer,DNT® Professional Automotive Tools&Hand Tools

Bearing Puller

Automotive Tools

Truck Repair Tools

Mechanic Tools

Plastic Auto Tools

Bearing Puller guide: choose right puller for your work

Bearing Puller guide: choose right puller for your work

Are you looking for a reliable manufacturer of down home textile products?

navigation

product

service support