Bearing Puller
Automotive Tools
- Wheel Bearing Removal Tool
- Ball Joint Separator
- Brake Caliper Tool
- Oil Filter Wrench
- Coil Spring Compressor
- Injector Puller
- Bush Tool
- Altermator Puller Puller
- Engine Timing Tools
- Clutch Alignment Tool
- Engine Compression Tester
- Engine Repair Tools
- Injector Seat Cutter
- Mechanic Creeper
- Oil Drain Plug Key Tool
- Fluid Oil Extractor
- Brake Bleeder
- Fuel Tank Wrench
- Wiper Arm Puller
- Motorcycle Chain Breaker
Truck Repair Tools
Mechanic Tools
Plastic Auto Tools
How to Replace Rod Bearings
How to Replace Rod Bearings
Connecting rod bearings are extremely important components of any engine, whether it's a Toyota or a Ferrari engine. Rod bearings ensure that the rods operate smoothly around the crankshaft on one end, and the piston wrist pins on the other end. Replacing the bearings on a motor is standard procedure for any engine rebuild.
Step 1
Remove the connecting rods from the pistons and crankshaft, if they are not already out. The rod's "big ends" (the larger end) are bolted to the crank with two bolts that hold the end cap on. The "small end" is held onto the wrist pin. The wrist pin is held onto the piston with two circlips. Remove these clips and slide the wrist pin out of the piston and the end of the rod. This should free the rod.
Step 2
Remove the old bearings. You can use a screwdriver and a hammer to GENTLY tap out the old bearings. Tap on the edge of the bearing where it meets the end cap and vice-versa. Do not tap the bearing out from the side.
Step 3
Clean the bearing surface of the rods on either end with a lint free rag. Carefully examine the bearing surfaces to make sure that there is absolutely no dirt or debris, as this can potentially cause bearing failure and shorten the life of the motor. Clean the bearings before installation, as well.
Step 4
Slide one bearing into the end of the rod's big end and one bearing into the end cap. The end cap and the rod end form the circle that goes around the crankshaft when everything is bolted together. The bearings have a small notch on either end. These notches should be opposite of each other when the rod and end cap are put together, NOT on the same side. This is important for proper oil pressure. Repeat this process for all of the rods. Make sure the bearings fit snugly within the connecting rod and do not have any loose play.
Step 5
The bearing on the small end of the rod should be pressed out with a press. If you do not have access to a press, you may be able to press the bearing out with a socket that just barely fits over the bearing, but is large enough to fit through the end of the rod. Carefully tap the bearing out and then tap in a new one. Be very careful not to damage the bearing.
Step 6
Install the rods on the crank with Plastigage (See Resources) between the crank and the rod. Tighten the rod bolts to the manufacturer's specifications. Remove the rod and check the Plastigage to make sure that the tolerances are correct.
Reinstall the rods to the crankshaft and the pistons and writs pins, using engine assembly lube. Tighten the rod bolts according to the manufacturer's specifications.
Are you looking for a reliable manufacturer of down home textile products?
We can quickly provide customers with market analysis, technical support and customized services.
- Ningbo Dongning Tools Co.,Ltd
- Professional Chinese Tools manufacturer on hand tools& automotive tools
- Address
- No.6 Falan Rd,Hengjie Town,Ningbo City,Zhejiang,China
- Phone
- 86-574-88298696 / 86-574-87070383
- info@nbdntools.com
subscription